Difference between revisions of "TUFLOW Message 1401"

From Tuflow
Jump to navigation Jump to search
(Created page with "{{TUFLOW_Message |tuflow_message=ERROR 1401 - Cannot connect Node with a X1DH link as the node is already connected to an external 1D domain via a X1DQ link. |alt_msg=NA |type=[[...")
 
(6 intermediate revisions by 4 users not shown)
Line 1: Line 1:
 
{{TUFLOW_Message
 
{{TUFLOW_Message
|tuflow_message=ERROR 1401 - Cannot connect Node with a X1DH link as the node is already connected to an external 1D domain via a X1DQ link.
+
|tuflow_message=CHECK 1401 - <x number> culvert(s) not used for determining losses at Manhole <Manhole ID>
 
|alt_msg=NA
 
|alt_msg=NA
|type=[[WARNING]]
+
|type=[[CHECK]]
|message_desc=A TUFLOW 1D (ESTRY) node is trying to be connected to an external 1D scheme using a X1DH link, but the TUFLOW node is already connected to an external 1D node using a X1DQ link.
+
|message_desc=When applying the Engelhund loss approach for manholes (see Section 4.5.2 of the 2010 TUFLOW manual), if an incoming culvert enters above the obvert of the highest outlet, the culvert is not included in the manhole loss calculations.  See also point 48(b) in the <u>[http://www.tuflow.com/Download/TUFLOW/Releases/2012-05/Doc/TUFLOW%20Release%20Notes.2011-09%20and%202012-05.pdf release notes]</u>.
|suggestions=Review connections to external 1D scheme for this node and remove the inappropriate one.
+
|suggestions=Review the inverts on the culverts.  A point object in a "1d_mh" layer can be used to set the loss approach at each manhole.
|discussion_page=* [[Talk:TUFLOW Message 1382|Discuss Message 1382]]
+
 
|link3=''
+
 
|link4=''
 
|prelink=[[TUFLOW_Message_1381|Message 1381]]
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1991|Message 1991]]
 
 
}}
 
}}

Revision as of 10:40, 23 December 2022

TUFLOW Message
CHECK 1401 - <x number> culvert(s) not used for determining losses at Manhole <Manhole ID>

Alternate Message
NA

Message Type
CHECK

Description
When applying the Engelhund loss approach for manholes (see Section 4.5.2 of the 2010 TUFLOW manual), if an incoming culvert enters above the obvert of the highest outlet, the culvert is not included in the manhole loss calculations. See also point 48(b) in the release notes.

Suggestions
Review the inverts on the culverts. A point object in a "1d_mh" layer can be used to set the loss approach at each manhole.


Up
Go-up.png 1xxx Messages