Difference between revisions of "TUFLOW Message 1011"

From Tuflow
Jump to navigation Jump to search
Line 7: Line 7:
 
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1).
 
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1).
 
|suggestions=If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node.
 
|suggestions=If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node.
|discussion_page=* [[Talk:TUFLOW Message 1011|Discuss Message 1011]]
+
 
|link3=''
 
|link4=''
 
 
|prelink=[[TUFLOW_Message_1010|Message 1010]]
 
|prelink=[[TUFLOW_Message_1010|Message 1010]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|nextlink=[[TUFLOW_Message_1012|Message 1012]]
 
|nextlink=[[TUFLOW_Message_1012|Message 1012]]
 
}}
 
}}

Revision as of 15:50, 1 July 2022

TUFLOW Message
ERROR 1011 - Exceeded limit of QT Region boundaries that can be applied to a single 1D Node.

Alternate Message
NA

Message Type
ERROR

Description
A region (polygon) can be used in a 1D boundary layer (type = "QT") to equally distribute the flow hydrograph to all nodes that fall within the region. Any nodes that are a H boundary or are connected to a 2D SX cell are not included.

As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1).

Suggestions
If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node.


Up
Go-up.png 1xxx Messages