Difference between revisions of "TUFLOW Message 1011"
Jump to navigation
Jump to search
Melissa1987 (talk | contribs) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1). | As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1). | ||
|suggestions=If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node. | |suggestions=If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node. | ||
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 13:38, 22 December 2022
TUFLOW Message
ERROR 1011 - Exceeded limit of QT Region boundaries that can be applied to a single 1D Node.
Alternate Message
NA
Message Type
ERROR
Description
A region (polygon) can be used in a 1D boundary layer (type = "QT") to equally distribute the flow hydrograph to all nodes that fall within the region. Any nodes that are a H boundary or are connected to a 2D SX cell are not included.
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1).
Suggestions
If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node.
| Up |
|---|
 1xxx Messages
|