Difference between revisions of "TUFLOW Message 1033"
Melissa1987 (talk | contribs) |
Melissa1987 (talk | contribs) |
||
| Line 8: | Line 8: | ||
Refer to section 4.6 of the 2010 TUFLOW Manual for more information. For detailed instructions on setting up the 1d_nwk and 1d_tab layers, refer to <u>[[Tutorial_Module04#1D_Cross-Sections | Module 4]]</u> of the Tutorial model. <br> | Refer to section 4.6 of the 2010 TUFLOW Manual for more information. For detailed instructions on setting up the 1d_nwk and 1d_tab layers, refer to <u>[[Tutorial_Module04#1D_Cross-Sections | Module 4]]</u> of the Tutorial model. <br> | ||
| − | + | ||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Revision as of 13:49, 22 December 2022
TUFLOW Message
ERROR 1033 - No XS line data downstream of channel "XXXX". Could not interpolate cross-section properties.
Alternate Message
ERROR 1033 - No XS line data upstream of channel "XXXX". Could not interpolate cross-section properties.
Message Type
ERROR
Description
Cross-Sectional data for the channel named "XXXX" cannot be found.
Suggestions
Each channel requires a table describing its hydraulic properties to define its conveyance. The properties are normally defined by digitising a cross-section in a 1d_tab layer positioned midway along the channel or at the channel ends. If the digitised cross section has more than two vertices, one must be snapped onto the 1D network. the 1d_tab layer references an external csv file (or similar formatted file) containing either a cross-section profile or a hydraulic properties table. The hydraulic properties can also be externally sourced from a Mike 11 or ISIS model. Note that structures such as culverts and weirs, are an exception to the rule. The attribute information supplied within the 1d_nwk table are sufficient to define the hydraulic properties.
Refer to section 4.6 of the 2010 TUFLOW Manual for more information. For detailed instructions on setting up the 1d_nwk and 1d_tab layers, refer to Module 4 of the Tutorial model.
| Up |
|---|
 1xxx Messages
|