Difference between revisions of "TUFLOW Message 1123"
m (Added schematic.) |
|||
| Line 5: | Line 5: | ||
|message_desc=Multiple cross-sections with the same priority have been found for channel. Mid channel cross-sections have higher priority than end cross-sections and will prevail. But if multiple mid channel cross-sections are found TUFLOW will give Error 1123. | |message_desc=Multiple cross-sections with the same priority have been found for channel. Mid channel cross-sections have higher priority than end cross-sections and will prevail. But if multiple mid channel cross-sections are found TUFLOW will give Error 1123. | ||
|suggestions=Check channel and cross-section configuration, remove unwanted cross-section.<br> | |suggestions=Check channel and cross-section configuration, remove unwanted cross-section.<br> | ||
| − | If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section. If this is not the case the cross-section may be treated as a mid cross-section. | + | If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section. If this is not the case the cross-section may be treated as a mid cross-section. An example of where this may occur is shown in the schematic below.<br><br> |
| + | [[File:Error 1123.jpeg|800px]] | ||
|discussion_page=* [[Talk:TUFLOW Message 1123|Discuss Message 1123]] | |discussion_page=* [[Talk:TUFLOW Message 1123|Discuss Message 1123]] | ||
|link3='' | |link3='' | ||
Revision as of 10:18, 2 September 2015
TUFLOW Message
ERROR 1123 - More than one cross-section line of same priority for channel
Alternate Message
NA
Message Type
ERROR
Description
Multiple cross-sections with the same priority have been found for channel. Mid channel cross-sections have higher priority than end cross-sections and will prevail. But if multiple mid channel cross-sections are found TUFLOW will give Error 1123.
Suggestions
Check channel and cross-section configuration, remove unwanted cross-section.
If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section. If this is not the case the cross-section may be treated as a mid cross-section. An example of where this may occur is shown in the schematic below.
| Up |
|---|
 1xxx Messages
|