Difference between revisions of "TUFLOW Message 1262"

From Tuflow
Jump to navigation Jump to search
 
(One intermediate revision by the same user not shown)
Line 5: Line 5:
 
|message_desc=Manning's n value assigned to channel is outside normal range.
 
|message_desc=Manning's n value assigned to channel is outside normal range.
 
|suggestions=Check Manning's n value for channel.  If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section.  In this case the Manning's n value may become 0.04 x 0.04 = 0.0016!
 
|suggestions=Check Manning's n value for channel.  If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section.  In this case the Manning's n value may become 0.04 x 0.04 = 0.0016!
|discussion_page=* [[Talk:TUFLOW Message 1262|Discuss Message 1262]]
+
 
|link3=''
+
 
|link4=''
 
|prelink=[[TUFLOW_Message_1261|Message 1261]]
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1264|Message 1264]]
 
 
}}
 
}}

Latest revision as of 16:00, 22 December 2022

TUFLOW Message
WARNING 1262 - Manning's n value of <Manning's n value> for channel <Channel ID> is unusually low or high.

Alternate Message
NA

Message Type
WARNING

Description
Manning's n value assigned to channel is outside normal range.

Suggestions
Check Manning's n value for channel. If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section. In this case the Manning's n value may become 0.04 x 0.04 = 0.0016!


Up
Go-up.png 1xxx Messages