Difference between revisions of "TUFLOW Message 2076"

From Tuflow
Jump to navigation Jump to search
 
(2 intermediate revisions by the same user not shown)
Line 6: Line 6:
 
<br>
 
<br>
 
The geometry control file (.tgc) file command:<br>
 
The geometry control file (.tgc) file command:<br>
<font color="green"><tt>Allow Dangling Z Lines == ON</tt></font><br>
+
<font color="blue"><tt>Allow Dangling Z Lines </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>ON</tt></font><br>
Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end.  This command may be used several times through a .tgc file to change the setting before different <font color="green"><tt>Read GIS Z Line == </tt></font> commands.  Elevations applied to dangling ends are displayed to the screen and log file.   
+
Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end.  This command may be used several times through a .tgc file to change the setting before different <font color="blue"><tt>Read GIS Z Line </tt></font><font color="red"><tt>== </tt></font> commands.  Elevations applied to dangling ends are displayed to the screen and log file.   
|suggestions=Add an elevation point to the end of the breakline or add the <font color="green"><tt>Allow Dangling Z Lines == ON</tt></font>.
+
|suggestions=Add an elevation point to the end of the breakline or add the <font color="blue"><tt>Allow Dangling Z Lines </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>ON</tt></font>.
|discussion_page=* [[Talk:TUFLOW Message 2076|Discuss Message 2076]]
+
 
|link3=''
+
 
|link4=''
 
|prelink=[[TUFLOW_Message_2075|Message 2075]]
 
 
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]]
 
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]]
|nextlink=[[TUFLOW_Message_2077|Message 2077]]
 
 
}}
 
}}

Latest revision as of 11:58, 23 December 2022

TUFLOW Message
WARNING 2076 - 3D breakline with snapped point(s) does not have a point at its end. 2D line assumed.

Alternate Message
NA

Message Type
WARNING

Description
3D breakline with snapped point(s) does not have a point at its end. The line is assumed to be a 2D break line (ie. a line of constant height). If using a breakline with elevaton points snapped anywhere along its length it should have points and the start and end of the line. In this case the elevation of the line oject is used.

The geometry control file (.tgc) file command:
Allow Dangling Z Lines == ON
Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end. This command may be used several times through a .tgc file to change the setting before different Read GIS Z Line == commands. Elevations applied to dangling ends are displayed to the screen and log file.

Suggestions
Add an elevation point to the end of the breakline or add the Allow Dangling Z Lines == ON.


Up
Go-up.png 2xxx Messages