Difference between revisions of "TUFLOW Message 2140"
Jump to navigation
Jump to search
Melissa1987 (talk | contribs) |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 10: | Line 10: | ||
* Putting a command in the wrong file, e.g. putting a geometry (.tgc) command in the boundary file (.tbc) | * Putting a command in the wrong file, e.g. putting a geometry (.tgc) command in the boundary file (.tbc) | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | + | ||
}} | }} | ||
Latest revision as of 13:39, 7 February 2023
TUFLOW Message
ERROR 2140 - Reading following line in control file.
Alternate Message
NA
Message Type
ERROR
Description
An error occurred reading the following line in the control file.
Suggestions
Check the line is a valid TUFLOW command for the version of TUFLOW that you are running. Common mistake are:
- Omitting the double equals (Set IWL = 0.6 not Set IWL == 0.6)
- Using the Read GIS syntax for versions of TUFLOW prior to 2010 (use Read MI instead).
- Using the Read RowCol syntax for versions of TUFLOW prior to 2010 (use Read MID instead).
- Putting a command in the wrong file, e.g. putting a geometry (.tgc) command in the boundary file (.tbc)
| Up |
|---|
 2xxx Messages
|