TUFLOW Message 1402

From Tuflow
Jump to: navigation, search

TUFLOW Message
CHECK 1402 - More than one culvert connected but could not create manhole at Node <Node ID>

Alternate Message

Message Type

When applying the Engelhund loss approach for manholes (see Section 4.5.2 of the 2010 TUFLOW manual), if an incoming culvert enters above the obvert of the highest outlet, the culvert is not included in the manhole loss calculations. If there is only 1 incoming pipe with the invert above the obvert of the outlet culvert, the incoming culvert is ignored and with no inlet culvert to the node a manhole is not possible. See also point 48(b) in the release notes.

Review the inverts on the culverts. A point object in a "1d_mh" layer can be used to set the loss approach at each manhole.


Previous Up Next
Go-prev.png Message 1401 Go-up.png 1xxx Messages Message 1421 Go-next.png