View source for Tutorial M10 003 Results QGIS

=Introduction=
QGIS is used to view the depth, velocity and water levels with the TUFLOW Viewer. For viewing of the 2D map results, see <u>[[Tutorial_M01_Results_QGIS | Module 1]]</u>.<br>
<br>

=Method=

Inspect depth, velocity and water level outputs:
<ol>
<li>Open the TUFLOW Viewer.
<li>Select File > Load Results. Navigate to the '''M10_5m_003.tcf''' in the  '''Module_10\TUFLOW\runs''' folder and open it.
<li>When prompted to open result GIS layers click 'Yes'.
<li>Select the 'Depth' and 'Vector Velocity' map output type in the Result Type panel.
<li>Use the Plot Time Series tool to see the time series of the flow at the location of the piping failure and dam failure. The time series shows the initial piping failure, followed by the dam failure:<br>
<br>
[[File:Animation M10 003 Results 01c.gif]]<br>
</ol><br>

=Conclusion=
:*The depth, velocity and flow were inspected over time at the location of the piping and dam failure.<br>
<br>

{{Tips Navigation
|uplink=[[Tutorial_M10#Results_3| Back to Module 10 Main Page]]
}}