View source for Tutorial M09 Results QGIS

=Introduction=
QGIS is used to load and view a range of event magnitudes and durations with the TUFLOW Viewer. For viewing of the 2D map results, see <u>[[Tutorial_M01_Results_QGIS | Module 1]]</u>.<br>
<br>

= TUFLOW Project Re-Configuration =
Re-configure the TUFLOW project to use and save empty files to the correct folder:<br>
<ol>
<li>Go to Plugins > TUFLOW > Editing > Configure / Create TUFLOW Project.
<li>Change the folder which contains TUFLOW to the '''Module_09''' folder. This is the only change required, the model folder structure and template empty files are supplied from previous model.<br>
Note: The 'results' and 'check' folder get automatically created when the TUFLOW model is run. <br>
<li>Click 'OK' and save the QGIS workspace by selecting Project > Save As.<br>
<br>
[[File:M09 Configure Project v3.png]]<br><br>
<li>Set the QGIS workspace projection to EPSG:32760, see <u>[https://wiki.tuflow.com/index.php?title=Tutorial_Site_Familiarisation_QGIS#Set_the_Projection Set the Projection]</u>.
</ol>
<br>

=Method=
Inspect the results for all events:
<ol>
<li>Open the TUFLOW Viewer.
<li>Load the results using the TCF. From File > Load Results, navigate to the '''Module_09\TUFLOW\runs''' folder and select the following file:
:*'''M09_5m_~e1~_~e2~_001.tcf''' 
<li>When prompted, click 'Select All' and 'Ok'. The TUFLOW Viewer opens all six simulation runs using event management:<br>
<br>
[[File:Animation_M09_Results_01b.gif]]<br>
<br>
<li>Inspect the extent, water level and the flows plot output for each event:<br>
<br>
[[File:Animation_M09_Results_02a.gif]]<br>
<br>
</ol><br>

=Conclusion=
:*The results of all event magnitudes and durations were inspected using the TUFLOW Viewer.
:*For further functionality, see <u>[[TUFLOW_Viewer | TUFLOW Viewer]]</u>.<br>
<br>

{{Tips Navigation
|uplink=[[Tutorial_M09#Results| Back to Module 9 Main Page]]
}}