TUFLOW Message 1011: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
Created page with '{{TUFLOW_Message |tuflow_message=ERROR 1011 - Exceeded limit of QT Region boundaries that can be applied to a single 1D Node. |alt_msg=NA |type=ERROR |message_desc=???? |sugg...' |
No edit summary |
||
| Line 3: | Line 3: | ||
|alt_msg=NA |
|alt_msg=NA |
||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc=A region (polygon) can be used in a 1D boundary layer (type = "QT") to equally distribute the flow hydrograph to all nodes that fall within the region. Any nodes that are a H boundary or are connected to a 2D SX cell are not included.<br> |
|||
|message_desc=???? |
|||
|suggestions=???? |
|||
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1). |
|||
|suggestions=If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node. |
|||
|discussion_page=* [[Talk:TUFLOW Message 1011|Discuss Message 1011]] |
|discussion_page=* [[Talk:TUFLOW Message 1011|Discuss Message 1011]] |
||
|link3='' |
|link3='' |
||
Revision as of 17:49, 6 February 2011
TUFLOW Message
ERROR 1011 - Exceeded limit of QT Region boundaries that can be applied to a single 1D Node.
Alternate Message
NA
Message Type
ERROR
Description
A region (polygon) can be used in a 1D boundary layer (type = "QT") to equally distribute the flow hydrograph to all nodes that fall within the region. Any nodes that are a H boundary or are connected to a 2D SX cell are not included.
As of Build 2008 08 AA, the limit on the number of 1D QT regions assigned to a 1D node is ten (10) - the limit previously was one (1).
Suggestions
If using a TUFLOW build latter than 2008-08-AA please ensure that less than ten (10) 1D QT regions select a single node.
| Up |
|---|
 1xxx Messages
|