TUFLOW Message 2306: Difference between revisions

|tuflow_message=ERROR 2306 - WrF value must be greater than zero.

|message_desc=Occurs when a WrF (Weir calibration factor for upstream controlled weir flow) of zero has been found. For "<tt>Wetting and Drying == ON Method B</tt>" which has been the default method since 2012-05 a non zero WrF must be specified. For "<tt>Wetting and Drying == ON</tt>" or "<tt>Defaults == Pre 2012</tt>" a zero value could be used to locally turn off the weir function.

|suggestions=Check for zero values that may have been inadvertently applied using one or a combination of the following commands: '''<tt>Read GIS WrF==''', '''Set WrF==''', '''Read RowCol WrF=='''</tt>.