Difference between revisions of "TUFLOW Message 2306"
Jump to navigation
Jump to search
(Extra information on 0 WrF for older versions) |
|||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=ERROR 2306 - WrF value must be greater than zero | + | |tuflow_message=ERROR 2306 - WrF value must be greater than zero. |
|alt_msg=NA | |alt_msg=NA | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc=Occurs when a WrF (Weir calibration factor for upstream controlled weir flow) of zero has been found. | + | |message_desc=Occurs when a WrF (Weir calibration factor for upstream controlled weir flow) of zero has been found. For "<tt>Wetting and Drying == ON Method B</tt>" which has been the default method since 2012-05 a non zero WrF must be specified. For "<tt>Wetting and Drying == ON</tt>" or "<tt>Defaults == Pre 2012</tt>" a zero value could be used to locally turn off the weir function. |
| − | |suggestions=Check for zero values that may have been inadvertently applied using one or a combination of the following commands: | + | |suggestions=Check for zero values that may have been inadvertently applied using one or a combination of the following commands: <tt>Read GIS WrF==, Set WrF==, Read RowCol WrF==</tt>. |
|discussion_page=* [[Talk:TUFLOW Message 2306|Discuss Message 2306]] | |discussion_page=* [[Talk:TUFLOW Message 2306|Discuss Message 2306]] | ||
|link3='' | |link3='' | ||
Revision as of 11:54, 14 February 2018
TUFLOW Message
ERROR 2306 - WrF value must be greater than zero.
Alternate Message
NA
Message Type
ERROR
Description
Occurs when a WrF (Weir calibration factor for upstream controlled weir flow) of zero has been found. For "Wetting and Drying == ON Method B" which has been the default method since 2012-05 a non zero WrF must be specified. For "Wetting and Drying == ON" or "Defaults == Pre 2012" a zero value could be used to locally turn off the weir function.
Suggestions
Check for zero values that may have been inadvertently applied using one or a combination of the following commands: Read GIS WrF==, Set WrF==, Read RowCol WrF==.
| Up |
|---|
 2xxx Messages
|