Difference between revisions of "TUFLOW Message 0037"
Jump to navigation
Jump to search
(Created page with "{{TUFLOW_Message |tuflow_message=ERROR 0037 - Could not apply Set IWL == AUTO. More than one different water level boundary found. |alt_msg=NA |type=ERROR |message_desc=I...") |
|||
| Line 10: | Line 10: | ||
|prelink=[[TUFLOW_Message_0036|Message 0036]] | |prelink=[[TUFLOW_Message_0036|Message 0036]] | ||
|uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | |uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | ||
| − | |nextlink=[[ | + | |nextlink=[[TUFLOW_Message_0038|Message 0038]] |
}} | }} | ||
Revision as of 14:11, 9 October 2018
TUFLOW Message
ERROR 0037 - Could not apply Set IWL == AUTO. More than one different water level boundary found.
Alternate Message
NA
Message Type
ERROR
Description
If using the Set IWL == Auto feature the IWL in the model is automatically set based on the water level at the downstream boundary. In this case more than one water level boundary has been encountered and TUFLOW is unable to set the IWL automatically.
Suggestions
Ensure that only a single water level boundary is used or remove the Set IWL == Auto command and set the IWL manually using the Set IWL == <value>, Read GIS IWL == <gis layer> or Read Grid IWL == <grid dataset> commands.
| Up |
|---|
 0xxx Messages
|