Difference between revisions of "TUFLOW Message 2839"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
|alt_msg=N/A | |alt_msg=N/A | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc= | + | |message_desc=This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models. |
| − | |suggestions= | + | |suggestions=Check that all PO lines are located within the model area. |
|discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]] | |discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]] | ||
|link3='' | |link3='' | ||
Revision as of 13:58, 14 August 2020
TUFLOW Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline[qpc_get_line_faces]
Alternate Message
N/A
Message Type
ERROR
Description
This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models.
Suggestions
Check that all PO lines are located within the model area.
| Up |
|---|
 2xxx Messages
|