Difference between revisions of "TUFLOW Message 0028"
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=ERROR 0028 - No " | + | |tuflow_message=ERROR 0028 - No "End Define" specified for "Define Event Name == <event_name>" |
|alt_msg=NA | |alt_msg=NA | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| Line 22: | Line 22: | ||
* <font color="blue"><tt>Start 2D Domain </tt></font><font color="red"><tt>== </tt></font> | * <font color="blue"><tt>Start 2D Domain </tt></font><font color="red"><tt>== </tt></font> | ||
* <font color="blue"><tt>If Scenario </tt></font><font color="red"><tt>== </tt></font> | * <font color="blue"><tt>If Scenario </tt></font><font color="red"><tt>== </tt></font> | ||
| − | + | ||
| − | |||
|uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | |uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 09:59, 22 December 2022
TUFLOW Message
ERROR 0028 - No "End Define" specified for "Define Event Name == <event_name>"
Alternate Message
NA
Message Type
ERROR
Description
No End Define command was found to close of the Define Event == block for the event.
Suggestions
Check the event file. Add the End Define command where it is missing.
Tip: When using commands such as Define Event == indent the commands within the block that follows as this makes it much easier to interpret which commands apply to which event definition. For example:
Define Event Name == 100y
- BC Event Source == _ARI_ | 100y
- Output Folder == ..\results_100y
End Define
Define Event Name == 06h
- BC Event Source == _Durn_ | 06h
- End Time == 9
End Define
Other examples of commands that benefit from indenting are:
- Start 2D Domain ==
- If Scenario ==
| Up |
|---|
 0xxx Messages
|