Difference between revisions of "TUFLOW Message 0505"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
|message_desc=An error caused by reporting locations being read in 1D block or in .ecf file. This error is also triggered when reporting locations are used in 2D only model. | |message_desc=An error caused by reporting locations being read in 1D block or in .ecf file. This error is also triggered when reporting locations are used in 2D only model. | ||
|suggestions=Place reporting locations command in .tcf outside of the 1D block. Make sure the model has 1D elements or change 0d_rl into 2d_po for 2D only models. | |suggestions=Place reporting locations command in .tcf outside of the 1D block. Make sure the model has 1D elements or change 0d_rl into 2d_po for 2D only models. | ||
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | |uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 11:39, 22 December 2022
TUFLOW Message
ERROR 0505 - Processing Reporting Location Lines. Check "Read GIS Reporting Locations" is not in a 1D block or in .ecf file.
Alternate Message
N/A
Message Type
ERROR
Description
An error caused by reporting locations being read in 1D block or in .ecf file. This error is also triggered when reporting locations are used in 2D only model.
Suggestions
Place reporting locations command in .tcf outside of the 1D block. Make sure the model has 1D elements or change 0d_rl into 2d_po for 2D only models.
| Up |
|---|
 0xxx Messages
|