Difference between revisions of "TUFLOW Message 1048"

From Tuflow
Jump to navigation Jump to search
 
(One intermediate revision by the same user not shown)
Line 5: Line 5:
 
|message_desc=The '''Number_of''' or '''No_of_Culverts''' attribute on the 1d_nwk file is not valid for bridge or weir channels.  For the channel ID specified, a value of greater than 1 has been specified and is being ignored.  For culverts this is the number of culvert barrels.  For example a value of 3 would indicate three parallel culverts.
 
|message_desc=The '''Number_of''' or '''No_of_Culverts''' attribute on the 1d_nwk file is not valid for bridge or weir channels.  For the channel ID specified, a value of greater than 1 has been specified and is being ignored.  For culverts this is the number of culvert barrels.  For example a value of 3 would indicate three parallel culverts.
 
|suggestions=As this attribute is not used by TUFLOW for a bridge or weir type channel, for clarity it is recommended that the attribute be left at 0 or 1.
 
|suggestions=As this attribute is not used by TUFLOW for a bridge or weir type channel, for clarity it is recommended that the attribute be left at 0 or 1.
|discussion_page=* [[Talk:TUFLOW Message 1048|Discuss Message 1048]]
+
 
|link3=''
 
|link4=''
 
|prelink=[[TUFLOW_Message_1045|Message 1045]]
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1049|Message 1049]]
 
 
}}
 
}}

Latest revision as of 14:27, 22 December 2022

TUFLOW Message
WARNING 1048 - For B or W channel <Channel ID> ignoring Number_of attribute value which is greater than 1.

Alternate Message
NA

Message Type
WARNING

Description
The Number_of or No_of_Culverts attribute on the 1d_nwk file is not valid for bridge or weir channels. For the channel ID specified, a value of greater than 1 has been specified and is being ignored. For culverts this is the number of culvert barrels. For example a value of 3 would indicate three parallel culverts.

Suggestions
As this attribute is not used by TUFLOW for a bridge or weir type channel, for clarity it is recommended that the attribute be left at 0 or 1.


Up
Go-up.png 1xxx Messages