Difference between revisions of "TUFLOW Message 1301"
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
* An ESTRY control file (.ecf) has been specified; or | * An ESTRY control file (.ecf) has been specified; or | ||
* Any 1D commands have been specified in the .tcf.<br> | * Any 1D commands have been specified in the .tcf.<br> | ||
| − | For example the following command in the .tcf will trigger a check for 1D nodes: <tt>"1D Output Folder == <output location> | + | For example the following command in the .tcf will trigger a check for 1D nodes: <tt><font color="blue">1D Output Folder </font><font color="red">== </font><output location></tt><br> |
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> | If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> | ||
<br> | <br> | ||
| Line 13: | Line 13: | ||
* Automatic 1D node creation is turned on and 1D channels have been specified | * Automatic 1D node creation is turned on and 1D channels have been specified | ||
* If manually specifying 1D nodes, make sure these are being read in correctly. | * If manually specifying 1D nodes, make sure these are being read in correctly. | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 10:25, 23 December 2022
TUFLOW Message
ERROR 1301 - No ESTRY nodes found.
Alternate Message
NA
Message Type
ERROR
Description
No 1D nodes have been found.
Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:
- An ESTRY control file (.ecf) has been specified; or
- Any 1D commands have been specified in the .tcf.
For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.
For a model with a 1D component, check that:
- Automatic 1D node creation is turned on and 1D channels have been specified
- If manually specifying 1D nodes, make sure these are being read in correctly.
| Up |
|---|
 1xxx Messages
|