TUFLOW Message 1301: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 7: | Line 7: | ||
* An ESTRY control file (.ecf) has been specified; or |
* An ESTRY control file (.ecf) has been specified; or |
||
* Any 1D commands have been specified in the .tcf.<br> |
* Any 1D commands have been specified in the .tcf.<br> |
||
For example the following command in the .tcf will trigger a check for 1D nodes: <tt> |
For example the following command in the .tcf will trigger a check for 1D nodes: <tt><font color="blue">1D Output Folder </font><font color="red">== </font><output location></tt><br> |
||
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> |
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> |
||
<br> |
<br> |
||
| Line 14: | Line 14: | ||
* If manually specifying 1D nodes, make sure these are being read in correctly. |
* If manually specifying 1D nodes, make sure these are being read in correctly. |
||
|prelink=[[TUFLOW_Message_1299|Message 1299]] |
|||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_1302|Message 1302]] |
|||
}} |
}} |
||
Latest revision as of 10:25, 23 December 2022
TUFLOW Message
ERROR 1301 - No ESTRY nodes found.
Alternate Message
NA
Message Type
ERROR
Description
No 1D nodes have been found.
Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:
- An ESTRY control file (.ecf) has been specified; or
- Any 1D commands have been specified in the .tcf.
For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.
For a model with a 1D component, check that:
- Automatic 1D node creation is turned on and 1D channels have been specified
- If manually specifying 1D nodes, make sure these are being read in correctly.
| Up |
|---|
 1xxx Messages
|