Tuflow

TUFLOW Message 2049: Difference between revisions

Browse history interactively
Content deleted Content added
VisualWikitext
Created page with '{{TUFLOW_Message |tuflow_message=???? |message_desc="Elevation point snapped to 2D breakline (Z Line) has an elevation of zero. Use .tgc command ""Zero Z Line Point == WARNING""...'
 
No edit summary
 
(4 intermediate revisions by 2 users not shown)
Line 1:
{{TUFLOW_Message
|tuflow_message=????ERROR 2049 - Elevation of point inside Z Shape region is zero.
|message_descalt_msg="ERROR 2049 - Elevation of point snapped to 2D breakline (Z Line) hasis anzero. elevation<br> ofERROR 2049 - Z values equal to zero were found. UseView _messages.tgcmif commandlayer. ""Zero<br> ZWARNING Line2049 Point- ==Elevation WARNING""of topoint issueinside theZ messageShape asregion is zero. a<br> WARNING and2049 not- asElevation anof ERRORpoint snapped to Z Line is zero."
|type=[[ERROR]] <br> [[WARNING]]
|suggestions=????
|message_desc=Elevation point snapped to 2D breakline (Z Line) has an elevation of zero. This usually occurs when data is missing from the elevation point, this error prevents an absolute elevation of 0m being mistakenly used on a breakline.
|discussion_page=* [[Talk:TUFLOW Message 2049|Discuss Message 2049]]
 
|link3=''
Use .tgc command <font color="blue"><tt>Zero Z Line Point </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>WARNING</tt></font> to issue the message as a WARNING and not as an ERROR.
|link4=''
|suggestions=If the zero value is incorrect and a non-zero elevation is intended fill in data or remove elevation point to interpolate from adjacent values. If you are wanting an elevation of 0m at a point, this check can be set to issue a warning or the zero elevation can be set to a value very close to zero e.g. 0.001m.
|prelink=[[TUFLOW_Message_2048|Message 2048]]
 
|nextlink=[[TUFLOW_Message_2050|Message 2050]]
 
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]]
}}
Retrieved from "https://wiki.tuflow.com/TUFLOW_Message_2049"