Difference between revisions of "TUFLOW Message 2108"
Jump to navigation
Jump to search
| (2 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|type=[[CHECK]] | |type=[[CHECK]] | ||
|message_desc=2D 1D/2D interface (HX) link applied more than once to 2D cell. This often occurs when the line registers a 2D cell twice. Usually not an issue, but may be an indicator that the line(s) have been digitised incorrectly or were accidentally repeated. | |message_desc=2D 1D/2D interface (HX) link applied more than once to 2D cell. This often occurs when the line registers a 2D cell twice. Usually not an issue, but may be an indicator that the line(s) have been digitised incorrectly or were accidentally repeated. | ||
| − | |suggestions= | + | |suggestions=Check boundary configuration to determine reason for repeat application, if duplicate or incorrectly digitised lines remove / rectify. |
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 12:34, 23 December 2022
TUFLOW Message
CHECK 2108 - 2D HX link applied more than once at cell.
Alternate Message
NA
Message Type
CHECK
Description
2D 1D/2D interface (HX) link applied more than once to 2D cell. This often occurs when the line registers a 2D cell twice. Usually not an issue, but may be an indicator that the line(s) have been digitised incorrectly or were accidentally repeated.
Suggestions
Check boundary configuration to determine reason for repeat application, if duplicate or incorrectly digitised lines remove / rectify.
| Up |
|---|
 2xxx Messages
|