Difference between revisions of "TUFLOW Message 2222"
Jump to navigation
Jump to search
(Created page with '{{TUFLOW_Message |tuflow_message=ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero. |alt_msg=NA |type=ERROR |message_desc=???? |suggestions...') |
|||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
|tuflow_message=ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero. | |tuflow_message=ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero. | ||
| − | |alt_msg= | + | |alt_msg=WARNING 2222 - Period attribute (eg. time taken for failure) is very short. |
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | + | [[WARNING]] | |
| − | + | |message_desc=The period attribute in a variable z shape layer (2d_vzsh) defines the time in hours over which the variation in Zpt elevations occurs. This <u>'''must'''</u> be greater than zero. From 2020-01-AB warning is issued if Period attribute is greater than zero, but below 0.01hr. Previously Period under 0.001hr was recognised as zero and error was issued. | |
| − | + | |suggestions=Set a valid period in the GIS layer and/or check the very short period is intentional. | |
| − | | | + | |
| − | |||
| − | | | ||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 14:13, 7 February 2023
TUFLOW Message
ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero.
Alternate Message
WARNING 2222 - Period attribute (eg. time taken for failure) is very short.
Description
The period attribute in a variable z shape layer (2d_vzsh) defines the time in hours over which the variation in Zpt elevations occurs. This must be greater than zero. From 2020-01-AB warning is issued if Period attribute is greater than zero, but below 0.01hr. Previously Period under 0.001hr was recognised as zero and error was issued.
Suggestions
Set a valid period in the GIS layer and/or check the very short period is intentional.
| Up |
|---|
 2xxx Messages
|