TUFLOW Message 2377: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 5: | Line 5: | ||
|message_desc=This command was made redundant as of Build 2009-05-AL and was replaced by the ability to apply wind stresses over time using “WT” 2D boundary conditions. |
|message_desc=This command was made redundant as of Build 2009-05-AL and was replaced by the ability to apply wind stresses over time using “WT” 2D boundary conditions. |
||
|suggestions=Use "WT" boundaries in a 2d_bc layer. |
|suggestions=Use "WT" boundaries in a 2d_bc layer. |
||
|discussion_page=* [[Talk:TUFLOW Message 2377|Discuss Message 2377]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_2376|Message 2376]] |
|||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_2381|Message 2381]] |
|||
}} |
}} |
||
Latest revision as of 09:46, 8 February 2023
TUFLOW Message
ERROR 2377 - Apply Wind Stresses command is redundant as of Build 2009-05-AL. Please refer to manual.
Alternate Message
NA
Message Type
ERROR
Description
This command was made redundant as of Build 2009-05-AL and was replaced by the ability to apply wind stresses over time using “WT” 2D boundary conditions.
Suggestions
Use "WT" boundaries in a 2d_bc layer.
| Up |
|---|
 2xxx Messages
|