Difference between revisions of "TUFLOW Message 2519"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
|message_desc=Any faces in the TIN surfaces that are marked with “i=1” to indicate that they are not visible are not used for setting elevations. Prior to 2018-03-AC these faces were used for setting elevations for any Z points that fell within the faces. | |message_desc=Any faces in the TIN surfaces that are marked with “i=1” to indicate that they are not visible are not used for setting elevations. Prior to 2018-03-AC these faces were used for setting elevations for any Z points that fell within the faces. | ||
|suggestions=NA | |suggestions=NA | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 09:16, 3 March 2023
TUFLOW Message
CHECK 2519 - Ignored invisible face for XML Surface.
Alternate Message
NA
Message Type
CHECK
Description
Any faces in the TIN surfaces that are marked with “i=1” to indicate that they are not visible are not used for setting elevations. Prior to 2018-03-AC these faces were used for setting elevations for any Z points that fell within the faces.
Suggestions
NA
| Up |
|---|
 2xxx Messages
|