TUFLOW Message 3038: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
Teegan.Burke (talk | contribs) Created page with "{{TUFLOW_Message |tuflow_message=ERROR 3038: Flow width factors must be >= 0. <br> |alt_msg=None |type=ERROR |message_desc=The value of specified Cell Width Factor must..." |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message |
{{TUFLOW_Message |
||
|tuflow_message=ERROR 3038 |
|tuflow_message=ERROR 3038 - Flow width factors must be >= 0. |
||
<br> |
<br> |
||
|alt_msg= |
|alt_msg=NA<br> |
||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc=Faces may have a flow width factor applied to represent reduced available flow area of the face (for example, if a building occupies part of the face).The changed flow width applies at all depths.<br> |
|||
|message_desc=The value of specified Cell Width Factor must be greater than 0.0. |
|||
:For example, a factor of 0.1 will limit the flow width to 10%. <br> |
|||
|suggestions=The Cell Width Factor can be used to adjust the 2D cell flow widths. It is a factor, for example 0.1 will limit the flow width to 10%. The changed flow width applies to all depths. When reading from a polygon object in GIS format, any cell sides that fall within the polygon will have the width factor applied. These factors can be reviewed within the uvpt_check file. |
|||
When reading from a polygon object in GIS format, any cell sides that fall within the polygon will have the width factor |
|||
applied. These factors can be reviewed within the uvpt_check file, and logically cannot be negative. |
|||
Negative factors are not permissible. |
|||
|suggestions=Review the applied face width factors and ensure none are less than 0. |
|||
|discussion_page=* [[Talk:TUFLOW Message 3038|Discuss Message 3038]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_3037|Message 3037]] |
|||
|uplink=[[3xxx_TUFLOW_Messages|3xxx Messages]] |
|uplink=[[3xxx_TUFLOW_Messages|3xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_3039|Message 3039]] |
|||
}} |
}} |
||
Latest revision as of 10:17, 3 March 2023
TUFLOW Message
ERROR 3038 - Flow width factors must be >= 0.
Alternate Message
NA
Message Type
ERROR
Description
Faces may have a flow width factor applied to represent reduced available flow area of the face (for example, if a building occupies part of the face).The changed flow width applies at all depths.
- For example, a factor of 0.1 will limit the flow width to 10%.
When reading from a polygon object in GIS format, any cell sides that fall within the polygon will have the width factor applied. These factors can be reviewed within the uvpt_check file, and logically cannot be negative. Negative factors are not permissible.
Suggestions
Review the applied face width factors and ensure none are less than 0.
| Up |
|---|
 3xxx Messages
|