1D Integrity Tool - Pipe Direction: Difference between revisions
Content deleted Content added
Ellis Symons (talk | contribs) |
|||
| (2 intermediate revisions by one other user not shown) | |||
Line 8:
===Outputs===
The following are output from the tool:
* Output point layer - an output log from the tool documenting where pipe directions were reversed.
* A temporary layer for each input with pipe direction corrected.
Line 13 ⟶ 14:
The following options are available:
<ul>
<li>'''Based on inverts''' - will change the pipe direction if there is an adverse gradient (downstream invert is higher than the upstream invert). Recommended only if it is apparent from an initial, manual inspection that the pipe dataset has occurrences of this error (i.e. not recommended to run this option by default without first confirming it's needed).<br><br>
''Note:<br>This option will only correct pipe direction if the adverse inverts are in the channel attribute data (i.e. if elevations are stored at the pits, then this option will not change the pipe direction).''<br><Br>
<li>'''Based on pipe direction continuity''' - This option will perform a basic check based on the incoming and outgoing pipe directions. If the
</ul>
<Br>
| |||