Difference between revisions of "TUFLOW Message 1253"

From Tuflow
Jump to navigation Jump to search
Line 13: Line 13:
 
* Check if the 1D network channel has both mid- and end- cross-sections. If both mid- and end- sections exist, TUFLOW will ignore the end-cross-sections in favour of the mid-cross-sections (Refer to the Mid Cross-Section and End Cross-section Chapters of the TUFLOW Manual)
 
* Check if the 1D network channel has both mid- and end- cross-sections. If both mid- and end- sections exist, TUFLOW will ignore the end-cross-sections in favour of the mid-cross-sections (Refer to the Mid Cross-Section and End Cross-section Chapters of the TUFLOW Manual)
 
* Check if cross-sections are both in the same location
 
* Check if cross-sections are both in the same location
* Check if the cross-section is snapped to a 1D network with overwrapping vertices upstream/downstream
+
* Check if the cross-section is snapped to a 1D network with overlapping vertices upstream/downstream. If there is an overlapping vertex, in QGIS it will show as green. Please, see the example image below:
 +
 
 +
<br>[[File:1d Network Overlapping Vertex.jpg||500px|]]<br>
 +
 
  
  
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
}}
 
}}

Revision as of 20:07, 23 July 2024

TUFLOW Message
WARNING 1253 - Unused 1d_ta line with attributes: ",a,",

Alternate Message
NA

Message Type
WARNING

Description
Unused data in table links (Read GIS Table Links == ). A unused link to tabular input has been found, tabular data can include cross-section profiles, cross-section hydraulic parameters, nodal surface areas or bridge loss coefficients. This can occur if:

  • A 1d_ta element with three or more vertices isn't snapped to a 1D network (1d_nwk) node
  • A 1d_ta element with two vertices does not intersect 1D network (1d_nwk) line
  • A channel in the 1D network has both end and mid cross sections
  • Two or more 1d_ta elements exist in the same location

Suggestions

  • Check if the 1d_ta object is linked to the 1D network (either snapped for a 1d_ta object with 3 or more vertices or just intersecting if the 1d_ta object has only 2 vertices)
  • Check if the 1D network channel has both mid- and end- cross-sections. If both mid- and end- sections exist, TUFLOW will ignore the end-cross-sections in favour of the mid-cross-sections (Refer to the Mid Cross-Section and End Cross-section Chapters of the TUFLOW Manual)
  • Check if cross-sections are both in the same location
  • Check if the cross-section is snapped to a 1D network with overlapping vertices upstream/downstream. If there is an overlapping vertex, in QGIS it will show as green. Please, see the example image below:


1d Network Overlapping Vertex.jpg


Up
Go-up.png 1xxx Messages