Difference between revisions of "TUFLOW Message 2904"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=WARNING 2904 - Failed to set up Mass Balance Output Interval. Set to "End Time - Start Time" | + | |tuflow_message=WARNING 2904 - Failed to set up Mass Balance Output Interval. Set to "End Time - Start Time". |
|alt_msg=NA | |alt_msg=NA | ||
|type=[[WARNING]] | |type=[[WARNING]] | ||
Latest revision as of 22:57, 9 September 2024
TUFLOW Message
WARNING 2904 - Failed to set up Mass Balance Output Interval. Set to "End Time - Start Time".
Alternate Message
NA
Message Type
WARNING
Description
The model has failed to set up a mass balance output interval and will instead use an interval of the end time, minus the start time. If you would like a more frequent interval, see the below suggestion.
Suggestions
Use one of the following commands:
- "Mass Balance Output Interval == "
- "Map Output Interval == "
- "Time Series Output Interval == "
Note, if using the Map Output Interval option, ensure that the value is being initialised. For example, for the following commands, the Map Output Interval command is used however as there is only one output format (TIF) and this is being set to an interval of 0 the mass balance output interval would not be initialised:
- Map Output Format == TIF
Map Output Interval == 300
TIF Map Output Interval == 0
| Up |
|---|
 2xxx Messages
|