Difference between revisions of "TUFLOW Message 2204"
Jump to navigation
Jump to search
(Created page with "{{TUFLOW_Message |tuflow_message=ERROR 2204 - Could not assign ISIS unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node. |alt_msg=NA |type=E...") |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=ERROR 2204 - Could not assign | + | |tuflow_message=ERROR 2204 - Could not assign Flood Modeller unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node. |
| − | |alt_msg= | + | |alt_msg=ERROR 2204 - Could not assign ISIS unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node. |
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc=TUFLOW could not connect the HX cells to the | + | |message_desc=TUFLOW could not connect the HX cells to the Flood Modeller unit. This may occur if the HX line is already connected to an ESTRY 1D channel |
| − | |suggestions=Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an | + | |suggestions=Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an Flood Modeller not directly or with an X connector. |
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | + | ||
}} | }} | ||
Latest revision as of 11:44, 5 February 2025
TUFLOW Message
ERROR 2204 - Could not assign Flood Modeller unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node.
Alternate Message
ERROR 2204 - Could not assign ISIS unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node.
Message Type
ERROR
Description
TUFLOW could not connect the HX cells to the Flood Modeller unit. This may occur if the HX line is already connected to an ESTRY 1D channel
Suggestions
Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an Flood Modeller not directly or with an X connector.
| Up |
|---|
 2xxx Messages
|