Check Files 2d fc

Contains information on the cell sides (U and V points) that have a flow constriction object applied. This contains information on the processed elevations, blockages and form loss values applied at the cell side.
Note: This file is only created for the older 2d_fc layers (Read GIS FC == ). The newer Layered Flow Constriction Shapes (2d_lfcsh) has a separate check file.

Attributes of _fc_check

Attribute Name	Attribute Description
Type	The flow constriction type: Blank for general "BC" for box culverts "BD" for bridge deck "FD" for floating bridge deck For further information, refer to the TUFLOW Manual.
Invert	The ground level of the z point.
Obvert_or_BC_Height	This attribute is dependent on the FC type: For a blank flow or "BD" constriction type this is the structure obvert. Above this elevation there is no additional flow area. For a "BC" constriction type this is the height of the box culvert. For a "FD" constriction type this is the depth of the object.
u_width_factor	The cell width factor applied in the U direction
v_width_factor	The cell width factor applied in the V direction
Add_form_loss	Additional Form Loss coefficient which is applied.
Mannings_n	For "BC" type constrictions the Manning's n value. For "BD" and "FD" this is used to specify additional roughness as per the TUFLOW Manual.
No_walls_or_neg_width	Only used for "BC" type constrictions. Number of vertical walls per grid cell. If set to zero (between 0.001 and 0.001) one vertical wall per cell is used. Alternatively, and more easily, specify the width of one culvert in metres by using a negative value. For example, if the culverts are 1.8m wide, enter a value of -1.8 and the number of vertical walls per cell is automatically calculated.
Blocked_sides	Indicates whether any of the walls of the constricted cell(s) are blocked off (ie. no flow across/through the side wall). One or more of the following letters in any order with in the field to indicated which wall(s) are blocked: R – block right hand side wall L – block left hand side wall T – block top side wall B – block bottom side wall
Invert_2	Not Used
Obvert_2	Not Used
Comment	Comment as specified on the input layer.

Up
TUFLOW Check Files