FM Tutorial M01 QGIS SHP 1D2D Links: Difference between revisions
Content deleted Content added
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
Line 38:
To digitise the CN lines, make the <b> 2d_bc_FMT_M01_HX_001_L.shp </b> layer editable and ensure snapping has been turned on. For each node in the <b>1d_x1d_FMT_M01_nodes_001_P.shp</b> layer, draw a line from the node to the HX line. The line must snap to both the node and the HX line, so it is recommended to use the snapping tool. Draw two lines for each node, one to the left bank and one to the right bank. In the 'Type' attribute of each line, type 'CN'. Assign the digitised CN lines an ‘f' attribute’ of ‘1’. This sets the weighting to be applied in distributing the water level from the 1D node to the 2D cell.<br>
<br>{{Video|name=Define 1D 2D Bdy Links 02 SHP.mp4 |width=1123}}<br>
<br>The figure below shows how the nodes are connected at the confluence. Note that all Flood Modeller nodes at the junction are present within the 1d_x1D_nodes layer, and are connected to the 2D domain. The HX lines are broken around the junction. </li>
Line 44 ⟶ 43:
[[File:FMT 1D-2D Linking Junction QGIS.JPG|900px]]
</br>▼
<li>Once all the CN and HX lines have been digitised along the tributary, save the file.</li>▼
▲<br><li>Once all the CN and HX lines have been digitised along the tributary, save the file.</li>
▲<br>
</br>
{{Tips Navigation
|uplink=[[Flood_Modeller_Tutorial_Module01_Provisional#Define Bank Elevations | Back to Tutorial Module 01 Main Page]]
}}
</ol>
| |||