Flood Modeller Tutorial Model: Difference between revisions

=Introduction=

The objective of this Flood Modeller – TUFLOW model is to demonstrate the ability of TUFLOW to link to an external 1D scheme and the various methods available in which to create this link. It is designed to supplement existing documentation and assumes the user has some prior knowledge of both the Flood Modeller and TUFLOW software packages.

Both TUFLOW and Flood Modeller have relatively modest system requirements for small models such as the tutorial model. However, larger and more complex models may have higher hardware requirements - in particular memory (RAM). Both software are available in 32 and 64 bit versions.

==Hardware==

===TUFLOW===

 

 

===Flood Modeller===

 

=Module Data=

 

=Recommended Reading=

The aim of this tutorial is to demonstrate the steps undertaken to build, review and visualise the results of a linked Flood Modeller – TUFLOW model. It assumes that the user has a good understanding of both the 1D component of Flood Modeller and the 1D and 2D components of TUFLOW. The following resources may be of use:

*[https://www.floodmodeller.com/media/34731/isis_1d_quick_start_guide.pdf Flood Modeller 1D Quick Start Guide]

=Modules=

The tutorial is presented over a series of modules, with each module offering the opportunity to run the model and review the results. Each of the modules builds upon the previous iteration with models developed in the previous module made available.

 

From this tutorial you will learn how to add a 1D pipe network and connect it to the representation of the watercourse created in Flood Modeller and link it to the TUFLOW representation of the floodplain created as part of [[Flood Modeller Tutorial Module01|Flood Modeller Tutorial Module 1]]. This tutorial is ideal for those who would like to learn more about the interaction of TUFLOW with Flood Modeller including the simulation of fully integrated drainage systems.