TUFLOW Message 1151: Difference between revisions
No edit summary |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
|message_desc=End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section. |
|message_desc=End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section. |
||
|suggestions=For channels other the "S" or "G" type channels, use a mid channel section. A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line. If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected. Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line. |
|suggestions=For channels other the "S" or "G" type channels, use a mid channel section. A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line. If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected. Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line. |
||
|discussion_page=* [[Talk:TUFLOW Message 1151|Discuss Message 1151]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_1146|Message 1146]] |
|||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_1152|Message 1152]] |
|||
}} |
}} |
||
Latest revision as of 15:29, 22 December 2022
TUFLOW Message
ERROR 1151 - Channel ",a," must be a G or S channel to use cross-sections at channel ends.
Alternate Message
NA
Message Type
ERROR
Description
End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section.
Suggestions
For channels other the "S" or "G" type channels, use a mid channel section. A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line. If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected. Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line.
| Up |
|---|
 1xxx Messages
|