TUFLOW Message 2222: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message |
{{TUFLOW_Message |
||
|tuflow_message=ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero. |
|tuflow_message=ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero. |
||
|alt_msg=WARNING 2222 - Period attribute (eg. time taken for failure) is very short. |
|||
|alt_msg=NA |
|||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
[[WARNING]] |
|||
|message_desc=The period attribute in a variable z shape layer (2d_vzsh) defines the time in hours over which the variation in Zpt elevations occurs. This <u>'''must'''</u> be greater than zero. |
|message_desc=The period attribute in a variable z shape layer (2d_vzsh) defines the time in hours over which the variation in Zpt elevations occurs. This <u>'''must'''</u> be greater than zero. From 2020-01-AB warning is issued if Period attribute is greater than zero, but below 0.01hr. Previously Period under 0.001hr was recognised as zero and error was issued. |
||
|suggestions=Set a valid period in the GIS layer. |
|suggestions=Set a valid period in the GIS layer and/or check the very short period is intentional. |
||
|discussion_page=* [[Talk:TUFLOW Message 2222|Discuss Message 2222]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_2221|Message 2221]] |
|||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_2223|Message 2223]] |
|||
}} |
}} |
||
Latest revision as of 14:13, 7 February 2023
TUFLOW Message
ERROR 2222 - Period attribute (eg. time taken for failure) must be greater than zero.
Alternate Message
WARNING 2222 - Period attribute (eg. time taken for failure) is very short.
Description
The period attribute in a variable z shape layer (2d_vzsh) defines the time in hours over which the variation in Zpt elevations occurs. This must be greater than zero. From 2020-01-AB warning is issued if Period attribute is greater than zero, but below 0.01hr. Previously Period under 0.001hr was recognised as zero and error was issued.
Suggestions
Set a valid period in the GIS layer and/or check the very short period is intentional.
| Up |
|---|
 2xxx Messages
|