Difference between revisions of "TUFLOW Message 2812"
Jump to navigation
Jump to search
| (2 intermediate revisions by 2 users not shown) | |||
| Line 5: | Line 5: | ||
|message_desc=This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level. | |message_desc=This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level. | ||
|suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | |suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 09:57, 3 March 2023
TUFLOW Message
WARNING 2812 - No quadtree nesting, largest nesting level = 1.
Alternate Message
NA
Message Type
WARNING
Description
This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level.
Suggestions
Omit this warning if it is intended to use one level, or check if nesting should be applied.
| Up |
|---|
 2xxx Messages
|