Difference between revisions of "TUFLOW Message 1343"
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
|suggestions=If there is a stepped increment in the 1d cross-section that you are trying to represent; it is possible to resolve this error by using a small increment of a millimetre between values in column 1 of the 1d_ta file. | |suggestions=If there is a stepped increment in the 1d cross-section that you are trying to represent; it is possible to resolve this error by using a small increment of a millimetre between values in column 1 of the 1d_ta file. | ||
| − | |||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 10:34, 23 December 2022
TUFLOW Message
ERROR 1343 - In ',A4,1X,a,' table above, Column 1 values not increasing. Values: ',a,' then
Alternate Message
NA
Message Type
ERROR
Description
The value in column 1 of the 1d_ta file does not increase as it progresses, as shown in the example below. This is usually the 'X' value for an XZ type table; or 'H' value for a HW type table.
Suggestions
If there is a stepped increment in the 1d cross-section that you are trying to represent; it is possible to resolve this error by using a small increment of a millimetre between values in column 1 of the 1d_ta file.
| Up |
|---|
 1xxx Messages
|