Difference between revisions of "TUFLOW Message 2839"
Jump to navigation
Jump to search
| (2 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
|message_desc=This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models. | |message_desc=This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models. | ||
| − | |suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area | + | |suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area. |
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 16:03, 23 February 2024
TUFLOW Message
ERROR 2839 - Unable to split polyline according to QPC mesh
Alternate Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline
Message Type
ERROR
Description
This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models.
Suggestions
Inspect line feature associated with the error message. Check that all PO lines are located within the model area.
| Up |
|---|
 2xxx Messages
|