TUFLOW Message 1031: Difference between revisions
Created page with '{{TUFLOW_Message |tuflow_message=ERROR 1031 - End of a WLL cannot snap to 1D node |alt_msg=ERROR 1031 - End of a WLL cannot snap to a 1D channel |type=ERROR |message_desc=???...' |
No edit summary |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 3: | Line 3: | ||
|alt_msg=ERROR 1031 - End of a WLL cannot snap to a 1D channel |
|alt_msg=ERROR 1031 - End of a WLL cannot snap to a 1D channel |
||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc= This error indicates that there is a configuration problem with the 1d_wll and 1d_nwk layers |
|||
|message_desc=???? |
|||
|suggestions=Load the messages, 1d_wll, 1d_nwk and 2d_bc layers into your GIS package. Using the messages layer, locate the area where the error occurs. <br> |
|||
|suggestions=???? |
|||
Check that the water level lines are configured correctly. <br> <br> |
|||
|discussion_page=* [[Talk:TUFLOW Message 1031|Discuss Message 1031]] |
|||
Remember: <br> |
|||
|link3='' |
|||
Water level lines should go left to right looking downstream.<br> |
|||
|link4='' |
|||
If the water level lines have only 2 vertices (no nodes on the lines, only a start and an end), then the line must go from 2d_bc to 2d_bc and '''cross''' the 1D network.<br> |
|||
|prelink=[[TUFLOW_Message_1030|Message 1030]] |
|||
If the water level line have 3 or more vertices, then the line must go from 2d_bc to 2d_bc and '''snap''' to the 1D network. <br> |
|||
For further information on configuring water level lines, refer to <u>[[Tutorial_M11 | Tutorial Module 11]]</u>. |
|||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_1032|Message 1032]] |
|||
}} |
}} |
||
Latest revision as of 11:47, 5 April 2024
TUFLOW Message
ERROR 1031 - End of a WLL cannot snap to 1D node
Alternate Message
ERROR 1031 - End of a WLL cannot snap to a 1D channel
Message Type
ERROR
Description
This error indicates that there is a configuration problem with the 1d_wll and 1d_nwk layers
Suggestions
Load the messages, 1d_wll, 1d_nwk and 2d_bc layers into your GIS package. Using the messages layer, locate the area where the error occurs.
Check that the water level lines are configured correctly.
Remember:
Water level lines should go left to right looking downstream.
If the water level lines have only 2 vertices (no nodes on the lines, only a start and an end), then the line must go from 2d_bc to 2d_bc and cross the 1D network.
If the water level line have 3 or more vertices, then the line must go from 2d_bc to 2d_bc and snap to the 1D network.
For further information on configuring water level lines, refer to Tutorial Module 11.
| Up |
|---|
 1xxx Messages
|