TUFLOW Message 1510: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
Steph.dufour (talk | contribs) Created page with "{{TUFLOW_Message |tuflow_message=CHECK 1402 - More than one culvert connected but could not create manhole at Node <Node ID> |alt_msg=NA |type=CHECK |message_desc=When app..." |
No edit summary |
||
| (8 intermediate revisions by 4 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message |
{{TUFLOW_Message |
||
|tuflow_message= |
|tuflow_message=ERROR 1510 - Invalid condition specified in operating control rule below. |
||
|alt_msg=NA |
|alt_msg=NA |
||
|type=[[ |
|type=[[ERROR]] |
||
|message_desc=The command specified within the .toc file is invalid. |
|||
|message_desc=When applying the Engelhund loss approach for manholes (see Section 4.5.2 of the 2010 TUFLOW manual), if an incoming culvert enters above the obvert of the highest outlet, the culvert is not included in the manhole loss calculations. If there is only 1 incoming pipe with the invert above the obvert of the outlet culvert, the incoming culvert is ignored and with no inlet culvert to the node a manhole is not possible. See also point 48(b) in the [http://www.tuflow.com/Download/TUFLOW/Releases/2012-05/Doc/TUFLOW%20Release%20Notes.2011-09%20and%202012-05.pdf release notes]. |
|||
|suggestions=The command producing the error will be outputted to the tlf file following the initial ERROR message. Check the syntax of the command line against guidance provided in the <u>[https://docs.tuflow.com/classic-hpc/manual/latest/ TUFLOW Manual]</u>. |
|||
|suggestions=Review the inverts on the culverts. A point object in a "1d_mh" layer can be used to set the loss approach at each manhole. |
|||
|discussion_page=* [[Talk:TUFLOW Message 1510|Discuss Message 1510]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_1402|Message 1402]] |
|||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_1527|Message 1527]] |
|||
}} |
}} |
||
Latest revision as of 09:13, 23 September 2024
TUFLOW Message
ERROR 1510 - Invalid condition specified in operating control rule below.
Alternate Message
NA
Message Type
ERROR
Description
The command specified within the .toc file is invalid.
Suggestions
The command producing the error will be outputted to the tlf file following the initial ERROR message. Check the syntax of the command line against guidance provided in the TUFLOW Manual.
| Up |
|---|
 1xxx Messages
|