TUFLOW Message 1301: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
Created page with '{{TUFLOW_Message |tuflow_message=ERROR 1301 - No ESTRY nodes found. |alt_msg=NA |type=ERROR |message_desc=???? |suggestions=???? |discussion_page=* [[Talk:TUFLOW Message 1301...' |
No edit summary |
||
| (6 intermediate revisions by 3 users not shown) | |||
| Line 3: | Line 3: | ||
|alt_msg=NA |
|alt_msg=NA |
||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc= |
|message_desc=No 1D nodes have been found. |
||
|suggestions=This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:<br> |
|||
|suggestions=???? |
|||
* An ESTRY control file (.ecf) has been specified; or |
|||
|discussion_page=* [[Talk:TUFLOW Message 1301|Discuss Message 1301]] |
|||
* Any 1D commands have been specified in the .tcf.<br> |
|||
|link3='' |
|||
For example the following command in the .tcf will trigger a check for 1D nodes: <tt><font color="blue">1D Output Folder </font><font color="red">== </font><output location></tt><br> |
|||
|link4='' |
|||
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> |
|||
|prelink=[[TUFLOW_Message_1298|Message 1298]] |
|||
<br> |
|||
For a model with a 1D component, check that:<br> |
|||
* Automatic 1D node creation is turned on and 1D channels have been specified |
|||
* If manually specifying 1D nodes, make sure these are being read in correctly. |
|||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_1302|Message 1302]] |
|||
}} |
}} |
||
Latest revision as of 10:25, 23 December 2022
TUFLOW Message
ERROR 1301 - No ESTRY nodes found.
Alternate Message
NA
Message Type
ERROR
Description
No 1D nodes have been found.
Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:
- An ESTRY control file (.ecf) has been specified; or
- Any 1D commands have been specified in the .tcf.
For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.
For a model with a 1D component, check that:
- Automatic 1D node creation is turned on and 1D channels have been specified
- If manually specifying 1D nodes, make sure these are being read in correctly.
| Up |
|---|
 1xxx Messages
|