TUFLOW Message 2049: Difference between revisions

Browse history interactively

← Older edit

Content deleted Content added

VisualWikitext

Revision as of 11:43, 1 October 2010 view source tuflow>Par No edit summary ← Older edit		Latest revision as of 11:15, 23 December 2022 view source Melissa.Moghanloo (talk \| contribs) Bureaucrats, Administrators 2,918 edits No edit summary
(3 intermediate revisions by 2 users not shown)
Line 3: \|alt_msg=ERROR 2049 - Elevation of point snapped to Z Line is zero. <br> ERROR 2049 - Z values equal to zero were found. View _messages.mif layer. <br> WARNING 2049 - Elevation of point inside Z Shape region is zero. <br> WARNING 2049 - Elevation of point snapped to Z Line is zero. \|type=[[ERROR]] <br> [[WARNING]] \|message_desc="Elevation point snapped to 2D breakline (Z Line) has an elevation of zero. ~~Use~~This ~~.tgc~~usually ~~command~~occurs ~~""Zero~~when Zdata ~~Line~~is ~~Point~~missing ==from ~~WARNING""~~the toelevation ~~issue~~point, ~~the~~this ~~message~~error asprevents aan ~~WARNING~~absolute ~~and~~elevation ~~not~~of as0m anbeing ~~ERROR~~mistakenly used on a breakline." ~~\|suggestions=????~~ Use .tgc command <font color="blue"><tt>Zero Z Line Point </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>WARNING</tt></font> to issue the message as a WARNING and not as an ERROR. ~~\|discussion_page=* [[Talk:TUFLOW Message 2049\|Discuss Message 2049]]~~ \|suggestions=If the zero value is incorrect and a non-zero elevation is intended fill in data or remove elevation point to interpolate from adjacent values. If you are wanting an elevation of 0m at a point, this check can be set to issue a warning or the zero elevation can be set to a value very close to zero e.g. 0.001m. ~~\|link3=''~~ ~~\|link4=''~~ ~~\|prelink=[[TUFLOW_Message_2048\|Message 2048]]~~ \|uplink=[[2xxx_TUFLOW_Messages\|2xxx Messages]] ~~\|nextlink=[[TUFLOW_Message_2050\|Message 2050]]~~ }}