Difference between revisions of "TUFLOW Message 2377"
Jump to navigation
Jump to search
(Created page with '{{TUFLOW_Message |tuflow_message=ERROR 2377 - This command is now redundant as of Build 2009-05-AL. Please refer to manual. |alt_msg=NA |type=ERROR |message_desc=???? |sugge...') |
|||
| (3 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=ERROR 2377 - | + | |tuflow_message=ERROR 2377 - Apply Wind Stresses command is redundant as of Build 2009-05-AL. Please refer to manual. |
|alt_msg=NA | |alt_msg=NA | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc= | + | |message_desc=This command was made redundant as of Build 2009-05-AL and was replaced by the ability to apply wind stresses over time using “WT” 2D boundary conditions. |
| − | |suggestions= | + | |suggestions=Use "WT" boundaries in a 2d_bc layer. |
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 09:46, 8 February 2023
TUFLOW Message
ERROR 2377 - Apply Wind Stresses command is redundant as of Build 2009-05-AL. Please refer to manual.
Alternate Message
NA
Message Type
ERROR
Description
This command was made redundant as of Build 2009-05-AL and was replaced by the ability to apply wind stresses over time using “WT” 2D boundary conditions.
Suggestions
Use "WT" boundaries in a 2d_bc layer.
| Up |
|---|
 2xxx Messages
|