Difference between revisions of "TUFLOW Message 1052"
| Line 4: | Line 4: | ||
|type=[[WARNING]] | |type=[[WARNING]] | ||
|message_desc=A skew angle can be used to adjust the cross-section properties for XZ and CS/HW data according to the skew angle. Useful where the cross-section line is surveyed oblique to the flow direction. The skew angle is zero degrees in the direction of flow and 90 degrees if surveyed a right angles(!) to the direction of flow. For example, a value of 45 adjusts the horizontal dimensions by dividing by the √2. | |message_desc=A skew angle can be used to adjust the cross-section properties for XZ and CS/HW data according to the skew angle. Useful where the cross-section line is surveyed oblique to the flow direction. The skew angle is zero degrees in the direction of flow and 90 degrees if surveyed a right angles(!) to the direction of flow. For example, a value of 45 adjusts the horizontal dimensions by dividing by the √2. | ||
| − | |suggestions=Cross-sections can't be | + | |suggestions=Cross-sections can't be perpendicular to flow direction. Specify a skew angle of 89.9 degrees or less.<br> |
| + | If converting from an older model with additional attributes in the 1d_xs layer, care should be taken that the 12th column is now treated as a skew angle. An additional "Skew Angle" angle should be added as the 12th column. | ||
|discussion_page=* [[Talk:TUFLOW Message 1052|Discuss Message 1052]] | |discussion_page=* [[Talk:TUFLOW Message 1052|Discuss Message 1052]] | ||
|link3='' | |link3='' | ||
Revision as of 14:54, 2 August 2013
TUFLOW Message
WARNING 1052 - Skew angle of ",a," exceeds limit of 89.9 degrees. Reduced to 89.9.
Alternate Message
NA
Message Type
WARNING
Description
A skew angle can be used to adjust the cross-section properties for XZ and CS/HW data according to the skew angle. Useful where the cross-section line is surveyed oblique to the flow direction. The skew angle is zero degrees in the direction of flow and 90 degrees if surveyed a right angles(!) to the direction of flow. For example, a value of 45 adjusts the horizontal dimensions by dividing by the √2.
Suggestions
Cross-sections can't be perpendicular to flow direction. Specify a skew angle of 89.9 degrees or less.
If converting from an older model with additional attributes in the 1d_xs layer, care should be taken that the 12th column is now treated as a skew angle. An additional "Skew Angle" angle should be added as the 12th column.
| Up |
|---|
 1xxx Messages
|