Difference between revisions of "TUFLOW Message 1152"
Jump to navigation
Jump to search
| Line 4: | Line 4: | ||
|type=[[CHECK]] | |type=[[CHECK]] | ||
|message_desc=A cross-section has been found at the channel centre (as opposed to channel ends), this takes priority and end-section(s) are being ignored. | |message_desc=A cross-section has been found at the channel centre (as opposed to channel ends), this takes priority and end-section(s) are being ignored. | ||
| − | |suggestions=Review channel and check a centre cross-section is intentional. | + | |suggestions=Review channel and check a centre cross-section is intentional. This usually happens with weirs and bridges embedded in 1D channels with their own cross section. |
|discussion_page=* [[Talk:TUFLOW Message 1152|Discuss Message 1152]] | |discussion_page=* [[Talk:TUFLOW Message 1152|Discuss Message 1152]] | ||
|link3='' | |link3='' | ||
Revision as of 10:29, 31 March 2021
TUFLOW Message
CHECK 1152 - For channel ",a,", using centre cross-section and ignoring end cross-section(s).
Alternate Message
NA
Message Type
CHECK
Description
A cross-section has been found at the channel centre (as opposed to channel ends), this takes priority and end-section(s) are being ignored.
Suggestions
Review channel and check a centre cross-section is intentional. This usually happens with weirs and bridges embedded in 1D channels with their own cross section.
| Up |
|---|
 1xxx Messages
|