TUFLOW Message 2839: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
{{TUFLOW_Message |
{{TUFLOW_Message |
||
|tuflow_message=ERROR 2839 - |
|tuflow_message=ERROR 2839 - Unable to split polyline according to QPC mesh |
||
|alt_msg=ERROR 2839 - Split polyline should not have more vertexes than the original polyline |
|||
|alt_msg=N/A |
|||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc=This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models. |
|message_desc=This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models. |
||
|suggestions=Check that all PO lines are located within the model area. |
|suggestions=Check that all PO lines are located within the model area, or contact [mailto:support@tuflow.com support@tuflow.com] for more support. |
||
|discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]] |
|discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]] |
||
|link3='' |
|link3='' |
||
Revision as of 09:59, 23 September 2020
TUFLOW Message
ERROR 2839 - Unable to split polyline according to QPC mesh
Alternate Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline
Message Type
ERROR
Description
This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models.
Suggestions
Check that all PO lines are located within the model area, or contact support@tuflow.com for more support.
| Up |
|---|
 2xxx Messages
|