Difference between revisions of "TUFLOW Message 2436"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
|alt_msg=NA | |alt_msg=NA | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc=Hydrographs were not accepted by the HPC solver. | + | |message_desc=Hydrographs were not accepted by the HPC solver. Prior to 2020-01-AC release this error was caused by multiplication factors f1 and f2 in the 2d_rf layer other than 1. |
| − | |suggestions= | + | |suggestions=Use the latest TUFLOW release. If multiplication factors other than 1 are used and TUFLOW version cannot be updated, multiplication should be applied to the source hydrographs rather than the factors f1 and f2.<br> |
| + | If the above doesn't apply, please contact support@tuflow.com. | ||
|discussion_page=* [[Talk:TUFLOW Message 2436|Discuss Message 2436]] | |discussion_page=* [[Talk:TUFLOW Message 2436|Discuss Message 2436]] | ||
|link3='' | |link3='' | ||
Revision as of 16:41, 18 September 2020
TUFLOW Message
ERROR 2436 - Sending hydrograph weights to HPC Solver.
Alternate Message
NA
Message Type
ERROR
Description
Hydrographs were not accepted by the HPC solver. Prior to 2020-01-AC release this error was caused by multiplication factors f1 and f2 in the 2d_rf layer other than 1.
Suggestions
Use the latest TUFLOW release. If multiplication factors other than 1 are used and TUFLOW version cannot be updated, multiplication should be applied to the source hydrographs rather than the factors f1 and f2.
If the above doesn't apply, please contact support@tuflow.com.
| Up |
|---|
 2xxx Messages
|