1D Integrity Tool - Continuity: Difference between revisions
Content deleted Content added
Ellis Symons (talk | contribs) |
Ellis Symons (talk | contribs) |
||
Line 18:
<li> '''Flow Area Check''' - will flag locations where the downstream flow area decreases.
<ul>
<li> % decrease - only relevant where more than one pipe is entering the downstream junction. Input value will determine the threshold at which the flow area is considered decreasing (e.g. 50% = the downstream flow area has to decrease by at least 50% of all incoming channels). The purpose of this setting is to prevent the amount of unnecessary flagging along 'trunk' pipes that don't increase or decrease in
</ul>
<li> '''Invert Check''' - will flag locations where either pipes have an adverse gradient, or where the invert of the outgoing pipe is higher than the invert of the incoming pipe. Will only flag locations where this is true for all incoming and outgoing pipes at any given junction.
| |||