Difference between revisions of "TUFLOW Message 1301"
Jump to navigation
Jump to search
Line 13: | Line 13: | ||
* Automatic 1D node creation is turned on and 1D channels have been specified | * Automatic 1D node creation is turned on and 1D channels have been specified | ||
* If manually specifying 1D nodes, make sure these are being read in correctly. | * If manually specifying 1D nodes, make sure these are being read in correctly. | ||
− | + | ||
− | |||
− | |||
|prelink=[[TUFLOW_Message_1299|Message 1299]] | |prelink=[[TUFLOW_Message_1299|Message 1299]] | ||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
|nextlink=[[TUFLOW_Message_1302|Message 1302]] | |nextlink=[[TUFLOW_Message_1302|Message 1302]] | ||
}} | }} |
Revision as of 15:34, 5 July 2022
TUFLOW Message
ERROR 1301 - No ESTRY nodes found.
Alternate Message
NA
Message Type
ERROR
Description
No 1D nodes have been found.
Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:
- An ESTRY control file (.ecf) has been specified; or
- Any 1D commands have been specified in the .tcf.
For example the following command in the .tcf will trigger a check for 1D nodes: "1D Output Folder == <output location>"
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.
For a model with a 1D component, check that:
- Automatic 1D node creation is turned on and 1D channels have been specified
- If manually specifying 1D nodes, make sure these are being read in correctly.
Up |
---|
1xxx Messages |